Mirage Sedan LS L4-1834cc 1.8L SOHC MFI (1999)
7. When not using the scan tool, proceed as follows:
1. Connect the special tool (test harness set) between the throttle position sensor connectors which have been disconnected. (Connect all
terminals taking care not to mistake the terminal No.)
2. Connect a digital voltmeter between the throttle position sensor terminal 2 (sensor output) and terminal 4 (sensor ground.)
3. Turn the ignition switch ON (but do not start the engine).
8. Check the throttle position sensor output voltage.
Standard value: 400-1,000 mV
9. If there is a deviation from the standard value, check the throttle position sensor and the related harness.
10. Remove the feeler gauge.
11. Switch OFF the ignition switch.
