Montero V6-3.8L SOHC (2005)
There is a clip (driver's side) or a claw (other sides) on the front of the power window switch assembly. Work from the front side using special tool
MB990784.
<<B>> DOOR INSIDE HANDLE COVER REMOVAL
1. Insert the special tool MB990784 between the inside handle upper part and the inside handle cover, and then disengage the upper claw of the
inside handle.
2. Disengage the lower claw of the inside handle in the same manner as for the upper claw.
3. Remove the door trim.
4. Remove the inside handle cover from the door trim.
INSTALLATION SERVICE POINT
>>A<< WATERPROOF FILM INSTALLATION
CAUTION: Be sure to apply the sealant below the inner panel water drain holes so as not to plug them.