Montero V6-3.8L SOHC (2005)
REMOVAL AND INSTALLATION
REMOVAL SERVICE POINT
<<A>> REAR BRAKE CALIPER ASSEMBLY REMOVAL
Remove the rear brake caliper assembly and support it with wire or something similar.
INSTALLATION SERVICE POINTS
>>A<< ADJUSTER ASSEMBLY INSTALLATION
Install the adjuster so that the shoe adjusting bolt for the left hand wheel is attached towards the rear of the vehicle, and the shoe adjusting bolt for
the right hand wheel is towards the front of the vehicle.
>>B<< SHOE-TO-ANCHOR SPRING INSTALLATION
CAUTION: The front and rear shoe-to-anchor springs are not interchangeable, so the spring with the paint mark must be installed at the rear side.
Install the shoe-to-anchor springs in the order shown in the illustration.
