Montero V6-3.8L SOHC (2005)
Radiator Cooling Fan Motor: Service and Repair
REMOVAL AND INSTALLATION
REMOVAL SERVICE POINT
<<A>> DRIVE BELT REMOVAL
The following operations will be needed due to the introduction of the serpentine drive system with the drive belt auto tensioner.
1. Insert a 12.7 mm (1/2 inch) breaker bar into the square hole on the drive belt auto tensioner, and rotate it clockwise until the tensioner touches
the stopper.
2. Align hole B with hole A, and insert a 5.0 mm (0.20 inch) Allen wrench to hold the tensioner. Then loosen the drive belt, and then remove the
drive belt auto tensioner.
