Montero V6-3.8L SOHC (2005)
P2100 - P2229
Items Indicated by the Malfunction Indicator Lamp (SERVICE ENGINE SOON or Check Engine Lamp)
NOTE: If the Malfunction Indicator Lamp (SERVICE ENGINE SOON or Check Engine Lamp) illuminates because of a malfunction of the powertrain
control module (PCM), communication between the scan tool MB991958 (MUT-III Sub Assembly) and the PCM is impossible. In this case, the
diagnostic trouble code cannot be read.
NOTE: After the PCM has detected a malfunction, the Malfunction Indicator Lamp (SERVICE ENGINE SOON or Check Engine Lamp) illuminates
when the engine is next turned on and the same malfunction is re-detected. However, for items marked with a "*" in the DTC NO. column, the
Malfunction Indicator Lamp (SERVICE ENGINE SOON or Check Engine Lamp) illuminates only on the first detection of the malfunction.
NOTE: After the Malfunction Indicator Lamp (SERVICE ENGINE SOON or Check Engine Lamp) illuminates, it will be switched off under the
following conditions.
-
When the PCM monitored the powertrain malfunction three times* and met set condition requirements, it detected no malfunction. *: In this case,
"one time" indicates from engine start to stop.
-
For misfiring or a fuel trim malfunction, when driving conditions (engine speed, engine coolant temperature, etc.) are similar to those when the
malfunction was first recorded.
NOTE: Sensor 1 indicates the sensor mounted at a position closest to the engine, and sensor 2 indicates the sensor mounted at the position second
closest to the engine.
NOTE: Bank 1 indicates the right bank side cylinder, and bank 2 indicates the left bank side cylinder.