Montero V6-3.8L SOHC (2005)
YES: Go to Step 9.
NO: Repair or replace it. Refer to Harness Connector Inspection. The RV meter should work normally.
STEP 9. Check the harness wires between D-07 (terminal 25) and ignition switch (ACC).
NOTE: Also check junction block connector D-208 and D-210, check the wires. If junction block connector D-208 and D-210 are damaged, repair or
replace them. Refer to Harness Connector Inspection.
Q: Is the harness wires between D-07 (terminal 25) and ignition switch (ACC) in good condition?
YES: There is no action to be taken.
NO: Repair them. The RV meter should work normally.
STEP 10. Recheck for malfunction.
Q: Is a malfunction eliminated?
YES: If no malfunctions are found in all steps, an intermittent malfunction is suspected. Refer to How to Use Troubleshooting/Inspection Service
Points - How to Cope with Intermittent Malfunction.
NO: Replace the RV meter.
Inspection Procedure 2
The Low Battery Warning Screen is Displayed.
