Montero V6-3.8L SOHC (2005)
3. When the function switch 1 is pressed on this screen, the screen is switched as follows.
-
When the function switch 1 [MONITOR] is pressed, the screen is switched to the monitor check mode.
-
When the "ADJ" switch [BACK] is pressed, the screen is switched to the service mode first menu screen.
-
When the "DISP" switch [END] is pressed, the service mode is terminated.
Automatic check mode
1. Press the "ADJ" switch with the ignition switch at "LOCK" (OFF) position, and while keeping on pressing, turn the ignition switch to the "ACC"
or "ON." position. When the" ADJ" switch is pressed continuously for more than five seconds, the service function is activated at the same time
with the reception signal (pip sound) and the first menu screen of the service mode is displayed.
2. Press the function switch 1 [AUTO] on the service mode first menu screen. The screen is switched to the automatic check mode. Follow the
on-screen instructions to turn the ignition switch to "ON." position.
3. Press the ignition switch is turned "ON." The communication and connection checks are performed. The checks will be finished with 10 seconds.
4. After the communication check and connection check are completed, the check results are displayed. Air-conditioner input (Auto, manual or less
are displayed.) Fuel gauge input (OK, full or disconnected are displayed.)
NOTE:
Auto: Automatic A/C
Manual or less: No-automatic A/C circuit or automatic A/C circuit open
OK: Some fuel in tank.
Full or Disconnected: Full tank of fuel or fuel level circuit open.
