Montero V6-3.8L SOHC (2005)
CAUTION: To prevent damage to scan tool M B991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991958.
1. Ensure that the ignition switch is at the "LOCK" (OFF) position.
2. Start up the personal computer.
3. Connect special tool MB991827 to special tool MB991824 and the personal computer.
4. Connect special tool MB991911 to special tool MB991824.
5. Connect special tool MB991911 to the data link connector.
6. Turn the power switch of special tool MB991824 to the "ON" position.
NOTE: When special tool MB991824 is energized, special tool MB991824 indicator light will be illuminated in a green color.
7. Start the MUT-III system on the personal computer.
8. Turn the ignition switch to the "ON" position. Select from scan tool menu screen as follows: [SYSTEM SELECT -> ABS -> ACTUATOR
TEST -> AIR BLEED]
9. Depress and hold the brake pedal.
10. Activate the actuator test [AIR BLEED (1) ]. When the scan tool flashes confirmation that the AIR BLEED (1) operation is completed,
proceed with AIR BLEED (2).
11. Depress and hold the brake pedal.
12. Select and activate [AIR BLEED (2) ] on the scan tool screen. When the scan tool flashes confirmation that the AIR BLEED (2) operation is
completed, go to step (7)
7. Bleed the rear brake system as follows (RH first, LH second):
CAUTION:
^
Keep the brake fluid reservoir level just above the "MIN" line at this time. Monitor the fluid level during this procedure to ensure it does not
reach below the "MIN" line.
^
If a large quantity of brake fluid is drained during the bleeding procedure, the accumulator pressure will decrease abnormally. Do not bleed
more than 0.1 dm3 (0.11quart) from each wheel at a time.
^
Confirm that the pump motor stops after each air-bleeding step.
1. Attach the clear hose to the RH caliper to monitor air/fluid flow.
2. Turn the ignition switch to the "ON" position.
3. Open bleeder valve 1/4 turn.
4. With the bleeder valve open, pump the brake pedal 3 times and hold.
5. Close the bleeder valve.
6. Pump the brake pedal 3 times and hold.
7. Open the bleeder valve 1/8 turn briefly to allow any remaining air to escape, then close the bleeder valve.
8. Repeat steps (6) and (7) as many times as necessary to eliminate all air in the line.
9. Repeat steps (1) - (8) at the LH caliper.
8. Bleed the front brake system as follows (RH first, LH second):
CAUTION:
