Montero V6-3.8L SOHC (2005)
STEP 4. Check the power window relay.
Properly identify and remove the relay from the under-dash junction block and test the relay using the chart as a guide.
Q: Is the power window relay in good condition?
YES: Go to Step 5.
NO: Replace the power window relay. Verify that the power windows function should now work normally.
STEP 5. Measure at power window relay connector D-219 in order to check the fusible link (4) line of power supply system to power window
relay.
1. Disconnect power window relay connector D-219, and measure at the junction block side.
2. Measure the voltage between terminal numbers 3, 5 and ground.
-
The voltage should be approximately 12 volts (battery positive voltage).
Q: Is the measured voltage approximately 12 volts (battery positive voltage)?
YES: Go to Step 7.
NO: Go to Step 6.
