Montero V6-3.8L SOHC (2005)
STEP 37. Check the harness wiring between power window relay connector D-219 (terminal 4) and rear power window sub-switch (RH)
connector H-19 (terminal 6).
NOTE: Also check junction block connector D-208 and intermediate connectors D-111 and F-23. If junction block connector D-208, intermediate
connector D-111 or F-23 is damaged, repair or replace the connector as described in Harness Connector Inspection.
Q: Is the harness wiring between power window relay connector (terminal 4) and rear power window sub-switch (RH) connector H-19 (terminal 6) in
good condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the rear power window sub-switch (RH) should now work normally.
STEP 38. Check at rear power window sub-switch (RH) connector H-19 in order to check the ground circuit to the rear power window
sub-switch (RH).
1. Disconnect rear power window sub-switch (RH) connector H-19, and measure at the harness side.
