Montero V6-3.8L SOHC (2005)
YES: Go to Step 2.
NO: Refer to Inspection Procedure H-1 "Rear wiper does not work at all."
STEP 2. Check the input signal by using "FUNCTION DIAG." menu of the SWS monitor.
Set each switch to the following condition before checking input signal from the transmission range switch ("R" position).
-
Ignition switch: ON
-
Rear wiper switch: ON
-
Shift position: "R" position
CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991958.
1. Connect the special tool. Refer to "How to connect SWS monitor". See: Reading and Clearing Diagnostic Trouble Codes/How to Connect SWS
Monitor
2. Connect SWS monitor kit MB991862 to the data link connector (13-pin).
3. Operate scan tool MB991958 according to the procedure below to display "REV. INTERLOCK."
1. Select "SYSTEM SELECT."
2. Select "SWS."
3. Select "SWS MONITOR."
4. Select "FUNCTION DIAG."
5. Select "REAR WIPER."
6. Select "REV. INTERLOCK."
4. Check that normal conditions are displayed on the item described in the given table.
Q: Are normal conditions displayed?
YES: Replace the ETACS-ECU. When the selector lever is moved to the "R" position, the rear wiper should operate consecutively approximately
twice.
NO: Refer to Inspection Procedure O-4 "ETACS-ECU does not receive "R" position signal from the transmission range switch."
Inspection Procedure H-4
Rear Wiper and Washer: The windshield washer does not work.
