Montero V6-3.8L SOHC (2005)
STEP 8. Check the wiring harness between rear washer motor connector I-08 (terminal 2) and ETACS-ECU connector D-222 (terminal 3).
NOTE: Also check intermediate connectors D-111,G-10 and junction block connector D-221 for loose, corroded, or damaged terminals, or terminals
pushed back in the connector. If intermediate connectors D-111,G-10 and junction block connector D-221 is damaged, repair or replace damaged
component(s) as described in Harness Connector Inspection.
Q: Is the wiring harness between rear washer motor connector I-08 (terminal 2) and ETACS-ECU connector D-222 (terminal 3) in good condition?
YES: Replace the ETACS-ECU. Verify that the rear washer works normally.
NO: The wiring harness may be damaged or the connector may have loose, corroded or damaged terminals, or terminals pushed back in the connector.
Repair the wiring harness as necessary. Verify that the rear washer works normally.
I - Charts
Seat Belt Warning Light: Seat belt warning light does not illuminate.
