Montero V6-3.8L SOHC (2005)
2. Measure the resistance value between terminal 1 and ground.
-
The resistance should equal 2 ohms or less.
Q: Is the measured resistance 2 ohms or less?
YES: No action is necessary and testing is complete.
NO: Go to Step 10.
STEP 10. Check the wiring harness between position light (LH) connector A-18 (terminal 1) and ground.
Q: Is the wiring harness between position light (LH) connector A-18 (terminal 1) and ground in good condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the position light illuminates normally.
STEP 11. Check the position light bulb (LH).
1. Remove the position light bulb (LH).
2. Verify that the position light bulb (LH) is not damaged or burned out.
Q: Is the position light bulb (LH) in good condition?
YES: Go to Step 12.
NO: Replace the position light bulb (LH). Verify that the position light (LH) illuminates normally.
