Montero V6-3.8L SOHC (2005)
STEP 35. Check the wiring harness between rear light (RH) connector G-12 (terminal 3) and ground.
NOTE: Also check intermediate connector F-10 for loose, corroded, or damaged terminals, or terminals pushed back in the connector. If intermediate
connector F-10 is damaged, repair or replace the damaged component(s) as described in Harness Connector Inspection.
Q: Is the wiring harness between rear light (RH) connector G-12 (terminal 3) and ground in good condition?
YES: Replace the rear combination light socket (RH). Verify that the taillight (RH) illuminates normally.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the taillight (RH) illuminates normally.
STEP 36. Check front-ECU connector A-07X for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is front-ECU connector A-07X in good condition?
YES: Go to Step 37.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the taillight (RH) illuminates normally.
