Montero V6-3.8L SOHC (2005)
NOTE: Also check intermediate connectors D-28, D-111 and G-10 for loose, corroded, or damaged terminals, or terminals pushed back in the
connector. If intermediate connector D-28, D-111 or G-10 is damaged, repair or replace the damaged component(s) as described in Harness Connector
Inspection.
Q: Is the wiring harness between license plate light assembly connector I-04 (terminal 2) and front-ECU connector A-07X (terminal 8) in good
condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the license plate lights illuminate normally.
STEP 44. Check the side marker light bulb (LH).
1. Remove the side marker light bulb (LH).
2. Verify that the side marker light bulb (LH) is not damaged or burned out.
Q: Is the side marker light bulb (LH) in good condition?
YES: Go to Step 45.
NO: Replace the side marker light bulb (LH). Verify that the side marker lights (LH) illuminates normally.
STEP 45. Check side marker light (LH) connector G-02 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is side marker light (LH) connector G-02 in good condition?
YES: Go to Step 46.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the side marker lights (LH) illuminates
normally.
STEP 46. Check the ground circuit to the side marker light (LH). Test at side marker light (LH) connector G-02.
1. Disconnect side marker light (LH) connector G-02 and measure the resistance available at the wiring harness side of the connector.
