Montero V6-3.8L SOHC (2005)
2. Measure the resistance value between terminal 4 and ground.
-
The resistance should equal 2 ohms or less.
Q: Is the measured resistance 2 ohms or less?
YES: Go to Step 48.
NO: Go to Step 47.
STEP 47. Check the wiring harness between side marker light (LH) connector G-02 (terminal 4) and ground.
Q: Is the wiring harness between side marker light (LH) connector G-02 (terminal 4) and ground in good condition?
YES: Replace the side marker light socket. Verify that the side marker light (LH) illuminates normally.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the side marker light (LH) illuminates normally.
STEP 48. Check front-ECU connector A-07X for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is front-ECU connector A-07X in good condition?
YES: Go to Step 49.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the side marker light (LH) illuminates
normally.
