Montero V6-3.8L SOHC (2005)
Q: Which turn-signal light does not illuminate?
Front turn-signal light (LH) : Go to Step 2.
Front turn-signal light (RH) : Go to Step 8.
Rear combination light (LH) : Go to Step 14.
Rear combination light (RH) : Go to Step 20.
Combination meter (LH) : Go to Step 26.
Combination meter (RH) : Go to Step 28.
Combination meter (both RH and LH) : Go to Step 30.
Front turn-signal light (LH) and combination meter (LH) : Go to Step 32.
LH side only : Refer to Inspection Procedure K-1 "Turn-signal lights do not flash when the turn signal light switch is operated."
RH side only : Refer to Inspection Procedure K-1 "Turn-signal lights do not flash when the turn signal light switch is operated."
Both LH and RH sides : Refer to Inspection Procedure K-2 "Hazard warning lights do not illuminate."
STEP 2. Check the front turn-signal light bulb (LH).
1. Remove the front turn-signal (LH) light bulb.
2. Verify that the front turn-signal light bulb (LH) is not damaged or burned out.
Q: Is the front turn-signal (LH) light bulb in good condition?
YES: Go to Step 3.
NO: Replace the front turn-signal (LH) light bulb. Verify that the turn-signal lights illuminate normally.
STEP 3. Check front turn-signal light (LH) connector A-19 for loose, corroded or damaged terminals, or terminals pushed back in the
connector.
Q: Is the front turn-signal light (LH) connector A-19 in good condition?
YES: Go to Step 4.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the turn-signal lights illuminate normally.
STEP 4. Check the ground circuit to the front combination light (LH). Test at front combination light (LH) connector A-19.
