Montero V6-3.8L SOHC (2005)
STEP 8. Check the wiring harness between theft-alarm indicator light connector D-105 (terminal 1) and ETACS-ECU connector D-224
(terminal 40).
Q: Is the wiring harness between theft-alarm indicator light connector D-105 (terminal 1) and ETACS-ECU connector D-224 (terminal 40) in good
condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. The theft-alarm indicator light should illuminate, and the theft-alarm system should be set normally.
STEP 9. Check the input signal by using "DATA LIST" menu of the SWS monitor.
Satisfy the following conditions to check the driver's and front passenger's door switches.
-
Driver's door: Open (driver's door switch is on) However, the door should be closed when checking the front passenger's door switch.
-
Front passenger's door: Open (front passenger's door switch is on) However, the door should be closed when checking the driver's door switch.
1. Connect the special tool. Refer to "How to connect SWS monitor". See: Reading and Clearing Diagnostic Trouble Codes/How to Connect SWS
