Montero V6-3.8L SOHC (2005)
STEP 5. Check the wiring harness between rear wiper motor connector I-07 (terminal 4) and the ignition switch (ACC).
NOTE: Also check intermediate connectors D-111, G-10, junction block connectors D-208 and D-217 for loose, corroded, or damaged terminals, or
terminals pushed back in the connector. If intermediate connector D-111, G-10, junction block connector D-208 or D-217 is damaged, Repair or replace
the damaged component(s) as described in Harness Connector Inspection.
Q: Is the wiring harness between rear wiper motor connector I-07 (terminal 4) and the ignition switch (ACC) in good condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. If the rear wiper operates normally, it indicates that a correct auto-stop signal is sent from the rear
wiper motor.
STEP 6. Check ETACS-ECU connector D-222 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Are rear ETACS-ECU connector D-222 in good condition?
