Montero V6-3.8L SOHC (2005)
STEP 7. Check the wiring harness between rear wiper motor connector I-07 (terminal 3) and ETACS-ECU connector D-222 (terminal 5).
NOTE: Also check intermediate connectors D-111, G-10 and junction block connector D-217 for loose, corroded, or damaged terminals, or terminals
pushed back in the connector. If intermediate connector D-111, G-10 or junction block connector D-217 is damaged, Repair or replace the damaged
component(s) as described in Harness Connector Inspection.
Q: Is the wiring harness between rear wiper motor connector I-07 (terminal 3) and ETACS-ECU connector D-222 (terminal 5) in good condition?
YES: Replace the ETACS-ECU. If the rear wiper operates normally, it indicates that a correct auto-stop signal is sent from the rear wiper motor.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. If the rear wiper operates normally, it indicates that a correct auto-stop signal is sent from the rear
wiper motor.
Inspection Procedure P-9
ETACS-ECU does not receive any signal from hood switch.