Montero V6-3.8L SOHC (2005)
STEP 6. Check the wiring harness between ETACS-ECU connector D-222 (terminal 20) and C-224 (terminal 23) and the ground.
NOTE: Also check junction block connector D-209 for loose, corroded, or damaged terminals, or terminals pushed back in the connector. If junction
block connector D-209 is damaged, repair or replace the damaged component(s) as described in Harness Connector Inspection.
Q: Is the wiring harness between ETACS-ECU connector D-222 (terminal 20) and D-224 (terminal 23) and the ground in good condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. The system should communicate with the ETACS-ECU normally.
STEP 7. Check column switch connector D-203 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is column switch connector D-203 in good condition?
