Montero V6-3.8L SOHC (2005)
STEP 7. Check the wiring harness between sunroof motor assembly connector F-02 (terminal 2) and ignition switch (IG2).
NOTE: Also check junction block connectors D-208, D-210, intermediate connectors D-26 and F-24 for loose, corroded, or damaged terminals, or
terminals pushed back in the connector. If junction block connector D-208, D-210, intermediate connectors D-26 or F-24 is damaged, repair or replace
the damaged component(s) as described in Harness Connector Inspection.
Q: Is the wiring harness between sunroof motor assembly connector F-02 (terminal 2) and the ignition switch (IG2) in good condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. The system should communicate with the sunroof motor assembly (sunroof-ECU) normally.
STEP 8. Check the ground circuit to the sunroof motor assembly. Test at sunroof motor assembly connector F-02.
1. Disconnect sunroof motor assembly connector F-02 and measure the resistance available at the wiring harness side of the connector.
