Montero V6-3.8L SOHC (2005)
STEP 25. Check the harness wiring from ETACS-ECU connector D-222 (terminal 17) to back door lock actuator connector I-05 (terminal 3).
NOTE: Also check junction block connector D-209 and intermediate connector D-111 and G-10 for loose, corroded, or damaged terminals, or
terminals pushed back in the connector. If junction block connector D-209 or intermediate connector D-111 or G-10 is damaged, repair or replace the
damaged component(s) as described in Harness Connector Inspection.
Q: Is the harness wiring from ETACS-ECU connector D-222 (terminal 17) to back door lock actuator connector I-05 (terminal 3) in good condition?
YES: Go to Step 26.
NO: The harness wiring may be damaged or the connectors may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the harness wiring as necessary. Verify that all the doors (including the back door) can be locked and unlocked normally.
