Montero V6-3.8L SOHC (2005)
-
The voltage should measure approximately 12 volts (battery positive voltage).
Q: Is the measured voltage approximately 12 volts (battery positive voltage)?
YES: Go to Step 25.
NO: Go to Step 23.
STEP 23. Check power window relay connector D-219 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is power window relay connector D-219 in good condition?
YES: Go to Step 24.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the rear power window sub-switch (LH) should
now work normally.
