Montero V6-3.8L SOHC (2005)
STEP 26. Check the harness wiring between power window main switch connector H-05 (terminal 1) and rear power window sub-switch (LH)
connector H-02 (terminal 8).
NOTE: Also check intermediate connectors, D-125, D-25 and F-12. If intermediate connector F-12, D-125 or D-25 is damaged, repair or replace the
damaged component(s) as described in Harness Connector Inspection.
Q: Is the harness wiring between power window main switch connector H-05 (terminal 1) and rear power window sub-switch (LH) connector H-02
(terminal 8) in good condition?
YES: Replace the power window main switch. Verify that the rear power window sub-switch (LH) should now work normally.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the rear power window sub-switch (LH) should now work normally.
STEP 27. Check at rear power window sub-switch (LH) connector H-02 in order to check the ground circuit to the rear power window
sub-switch (LH).
1. Disconnect rear power window sub-switch (LH) connector H-02, and measure at the harness side.
