Montero V6-3.8L SOHC (2005)
Windshield Wiper Automatic Stop Relay Circuit Part 2
TECHNICAL DESCRIPTION (COMMENT)
If the windshield wiper does not stop at predetermined park position, the windshield wiper motor or the front-ECU may be defective.
TROUBLESHOOTING HINTS
-
The windshield wiper motor may be defective
-
The front-ECU may be defective
-
The wiring harness or connectors may have loose, corroded, or damaged terminals, or terminals pushed back in the connector
DIAGNOSIS
Required Special Tool:
-
MB991223: Harness Set
STEP 1. Check windshield wiper motor connector B-12 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is windshield wiper motor connector B-12 in good condition?
YES: Go to Step 2.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. The windshield wiper should now stop at the
predetermined park position.
STEP 2. Check the windshield wiper motor.
1. Disconnect windshield wiper motor connector B-12.
