Montero V6-3.8L SOHC (2005)
2. Connect the windshield wiper motor connector terminal 4 to the positive battery terminal and terminal 5 to the ground as shown in the illustration
(A), and operate the windshield wiper at low speed. While the windshield wiper is working, disconnect the battery at positions other than the
predetermined park position to stop the windshield wiper motor.
3. When connect the windshield wiper motor connector terminal 2 to the positive battery terminal, terminal 5 to the ground and terminal 3 to terminal
4 as shown in the illustration (B), the motor should run at low speed, and then stop at the predetermined park position.
Q: Does the windshield wiper motor operate normally?
YES: Go to Step 3.
NO: Replace the windshield wiper motor. Verify the windshield wiper should now stop at the predetermined park position.
STEP 3. Check the battery power supply circuit to the windshield wiper motor. Test at the windshield wiper motor connector B-12.
1. Disconnect windshield wiper motor connector B-12 and measure the voltage available at the wiring harness side of the connector.
2. Turn the ignition switch to the "ACC" position.
