Montero V6-3.8L SOHC (2005)
STEP 6. Check combination meter connector D-03 and D-04 for loose, corroded or damaged terminals, or terminals pushed back in the
connector.
Q: Are combination meter connector D-03 and D-04 in good condition?
YES: Go to Step 7.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the seat belt warning light illuminates normally.
STEP 7. Check the seat belt warning light bulb.
Q: Is the seat belt warning light bulb in good condition?
YES: Go to Step 8.
NO: Replace the bulb. Verify that the seat belt warning light illuminates normally.
STEP 8. Check the combination meter (printed-circuit board).
1. Remove the combination meter.
2. Remove the seat belt warning light bulb. Then measure the resistance value between the bulb terminals.
