Montero V6-3.8L SOHC (2005)
STEP 5. Check the wiring harness between rear combination light (RH) connector G-09 (terminal 1) and front-ECU connector A-07X
(terminal 8).
NOTE: Also check intermediate connectors D-28 and D-111 for loose, corroded, or damaged terminals, or terminals pushed back in the connector. If
intermediate connector D-28 or D-111 is damaged, repair or replace the damaged component(s) as described in Harness Connector Inspection.
Q: Is the wiring harness between rear combination light (RH) connector G-09 (terminal 1) and front-ECU connector A-07X (terminal 8) in good
condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the taillight (RH) and side marker light (RH) illuminates normally.
STEP 6. Check taillight (LH) connector G-16 and front-ECU connector A-07X for loose, corroded or damaged terminals, or terminals pushed
back in the connector.
