Montero V6-3.8L SOHC (2005)
STEP 25. Check the wiring harness between rear light (LH) connector G-16 (terminal 3) and ground.
NOTE: Also check intermediate connector F-10 for loose, corroded, or damaged terminals, or terminals pushed back in the connector. If intermediate
connector F-10 is damaged, repair or replace the damaged component(s) as described in Harness Connector Inspection.
Q: Is the wiring harness between rear light (LH) connector G-16 (terminal 3) and ground in good condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the taillights illuminate normally.
Part 3 of 4
STEP 26. Check the taillight bulb (LH).
1. Remove the taillight bulb (LH).
2. Verify that the taillight bulb (LH) is not damaged or burned out.
Q: Is the taillight bulb (LH) in good condition?
YES: Go to Step 27.
NO: Replace the taillight bulb (LH). Verify that the taillights (LH) illuminates normally.
STEP 27. Check rear light (LH) connector G-16 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is rear light (LH) connector G-16 in good condition?
YES: Go to Step 28.
