Montero V6-3.8L SOHC (2005)
STEP 31. Check the wiring harness between rear light (LH) connector G-16 (terminal 1) and front-ECU connector A-07X (terminal 8).
NOTE: Also check intermediate connectors D-28, D-111 and F-10 for loose, corroded, or damaged terminals, or terminals pushed back in the
connector. If intermediate connector D-28, D-111 or F-10 is damaged, repair or replace the damaged component(s) as described in Harness Connector
Inspection.
Q: Is the wiring harness between rear light (LH) connector G-16 (terminal 1) and front-ECU connector A-07X (terminal 8) in good condition?
YES: Replace the rear combination light socket (LH). Verify that the taillights (LH) illuminates normally.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the taillights (LH) illuminates normally.
STEP 32. Check the taillight bulb (RH).
1. Remove the taillight bulb (RH).
2. Verify that the taillight bulb (RH) is not damaged or burned out.
Q: Is the taillight bulb (RH) in good condition?
YES: Go to Step 33.
NO: Replace the taillight bulb (RH). Verify that the taillight (RH) illuminates normally.
