Montero V6-3.8L SOHC (2005)
2. Measure the resistance value between terminal 1 and ground.
-
The resistance should equal 2 ohms or less.
Q: Is the measured resistance 2 ohms or less?
YES: Go to Step 42.
NO: Go to Step 41.
STEP 41. Check the wiring harness between license plate light assembly connector I-04 (terminal 1) and ground.
Q: Is the wiring harness between license plate light assembly connector I-04 (terminal 1) and ground in good condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the license plate lights illuminate normally.
STEP 42. Check front-ECU connector A-07X for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is front-ECU connector A-07X in good condition?
YES: Go to Step 43.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the license plate lights illuminate normally.
