Montero V6-3.8L SOHC (2005)
STEP 6. Check the wiring harness between ETACS-ECU connector D-222 (terminal 11) and the battery.
NOTE: Also check intermediate connector D-28 and junction block connector D-221 for loose, corroded, or damaged terminals, or terminals pushed
back in the connector. If intermediate connector D-28 or junction block connector D-221 is damaged, repair or replace the damaged component(s) as
described in Harness Connector Inspection.
Q: Is the wiring harness between ETACS-ECU connector D-222 (terminal 11) and the battery in good condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the turn-signal lights illuminate normally.
STEP 7. Check the input signal by using "FUNCTION DIAG." menu of the SWS monitor.
Check the input signals from the following switches:
-
Ignition switch: ON
-
Turn-signal light switch: RH
CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991958.
