Montero V6-3.8L SOHC (2005)
STEP 7. Check the wiring harness between front turn-signal light (LH) connector A-19 (terminal 1) and ETACS-ECU connector D-222
(terminal 15).
NOTE: Also check junction block connector D-212, joint connector A-16 and intermediate connector D-28 for loose, corroded, or damaged terminals,
or terminals pushed back in the connector. If junction block connector D-212, joint connector A-16 or intermediate connector D-28 is damaged, repair or
replace the damaged component(s) as described in Harness Connector Inspection.
Q: Is the wiring harness between front turn-signal light (LH) connector A-19 (terminal 1) and ETACS-ECU connector D-222 (terminal 15) in good
condition?
YES: Replace the socket. Verify that the turn-signal lights illuminate normally.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the turn-signal lights illuminate normally.
STEP 8. Check the front turn-signal light bulb (RH).
1. Remove the front turn-signal (RH) light bulb.
2. Verify that the front turn-signal light bulb (RH) is not damaged or burned out.
Q: Is the front turn-signal (RH) light bulb in good condition?
YES: Go to Step 9.
NO: Replace the front turn-signal (RH) light bulb. Verify that the turn-signal lights illuminate normally.
STEP 9. Check front turn-signal light (RH) connector A-35 for loose, corroded or damaged terminals, or terminals pushed back in the
connector.
