Montero V6-3.8L SOHC (2005)
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the fog lights illuminate normally.
STEP 10. Check the ground circuit to the fog light (RH). Test at fog light (RH) connector A-31.
1. Disconnect fog light (RH) connector A-31 and measure the resistance available at the wiring harness side of the connector.
2. Measure the resistance value between terminal 2 and ground.
-
The resistance should equal 2 ohms or less.
Q: Is the measured resistance 2 ohms or less?
YES: Go to Step 12.
NO: Go to Step 11.
