Montero V6-3.8L SOHC (2005)
1. Disconnect fog light (LH) connector A-21 and measure the resistance available at the wiring harness side of the connector.
2. Measure the resistance value between terminal 2 and ground.
-
The resistance should equal 2 ohms or less.
Q: Is the measured resistance 2 ohms or less?
YES: Go to Step 22.
NO: Go to Step 21.
STEP 21. Check the wiring harness between fog light (LH) connector A-21 (terminal 2) and ground.
NOTE: Also check intermediate connector A-25 for loose, corroded, or damaged terminals, or terminals pushed back in the connector. If intermediate
connector A-25 is damaged, repair or replace the damaged component(s) as described in Harness Connector Inspection.
Q: Is the wiring harness between fog light (LH) connector A-21 (terminal 2) and ground in good condition?
