Montero V6-3.8L SOHC (2005)
YES: Go to Step 16.
NO: Replace the bulb. Verify that the dome light illuminates normally.
STEP 16. Check dome light connector F-03 for damage.
Q: Is dome light connector F-03 in good condition?
YES: Go to Step 17.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. Verify that the dome light illuminates normally.
STEP 17. Check the fusible link (1) line of the power supply circuit to the dome light. Test at dome light connector F-03.
1. Disconnect dome light connector F-03 and measure the voltage available at the wiring harness side of the connector.
2. Measure the voltage between terminal 1 and ground.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES: Replace the dome light. Verify that the dome light illuminates normally.
NO: Go to Step 18.
