mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2875 > < Initial Inspection and Diagnostic Overview|Page 2873
Page 416
background image

in the connector.

Q: Are joint connector (3) A-17 and horn (high) connector A-27 in good condition

YES: Go to Step 23.

NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. All the vehicle horn (including the theft-alarm horn)
should sound when the theft-alarm system is triggered.

STEP 23. Check the wiring harness between joint connector (3) A-17 (terminal 2) and horn (high) connector A-27 (terminal 1).

Q: Is the wiring harness between joint connector (3) A-17 (terminal 2) and horn (high) connector A-27 (terminal 1) in good condition?

YES: Go to Step 26.

NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. All the vehicle horn (including the theft-alarm horn) should sound when the theft-alarm system is
triggered.

Initial Inspection and Diagnostic Overview|Page 2875 > < Initial Inspection and Diagnostic Overview|Page 2873