Montero V6-3.8L SOHC (2005)
STEP 1. Check ETACS-ECU connector D-222 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is ETACS-ECU connector D-222 in good condition?
YES: Go to Step 2.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. If the equipment, which are described in "CIRCUIT
OPERATION", work normally, the input signal from the ignition switch (ACC) should be normal.
STEP 2. Check the ignition switch (ACC) circuit to the ETACS-ECU. Test at ETACS-ECU connector D-222.
1. Disconnect ETACS-ECU connector D-222 and measure the voltage available at the junction block side of the connector.
2. Turn the ignition switch to the "ACC" position.
3. Measure the voltage between terminal 2 and ground.
-
The voltage should equal approximately 12 volts (battery positive voltage).
Q: Is the measured voltage approximately 12 volts (battery positive voltage)?
YES: Replace the ETACS-ECU. If the equipment, which are described in "CIRCUIT OPERATION", work normally, the input signal from the
ignition switch (ACC) should be normal.
NO: Go to Step 3.
