Montero V6-3.8L SOHC (2005)
STEP 8. Check the passenger's door switch.
Remove the passenger's door switch. Then check the continuity between the switch terminals and the switch body.
Q: Is the passenger's door switch in good condition?
YES: Go to Step 9.
NO: Replace the passenger's door switch. If the functions, which are described in "CIRCUIT OPERATION", work normally, the input signal from the
passenger's door switch should be normal.
STEP 9. Measure at the lower metal part of the passenger's door switch in order to check the ground circuit to the passenger's door switch.
NOTE: Check that the passenger's door switch is grounded to the vehicle body by means of its mounting screw.
Remove the cap, and measure the resistance value between the lower metal part and the ground.
-
The resistance should equal 2 ohms or less.
Q: Is the measured resistance 2 ohms or less?
YES: Go to Step 10.
NO: Check the fit of the switch, and repair if necessary. If the functions, which are described in "CIRCUIT OPERATION", work normally, the input
signal from the passenger's door switch should be normal.
STEP 10. Check ETACS-ECU connector D-224 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is ETACS-ECU connector D-224 in good condition?
YES: Go to Step 11.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. If the functions, which are described in "CIRCUIT
OPERATION", work normally, the input signal from the passenger's door switch should be normal.
