Montero V6-3.8L SOHC (2005)
1. Disconnect hood switch connector A-14 and measure the resistance available at the wiring harness side of the connector.
2. Measure the resistance value between terminal 2 and ground.
-
The resistance should equal 2 ohms or less.
Q: Is the measured resistance 2 ohms or less?
YES: Go to Step 5.
NO: Go to Step 4.
STEP 4. Check the wiring harness between hood switch connector A-14 (terminal 2) and ground.
Q: Is the wiring harness between hood switch connector A-14 (terminal 2) and the ground in good condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. If the theft-alarm system operates normally, it indicates that a correct signal is sent from the hood
switch.
