Montero V6-3.8L SOHC (2005)
b.
Connect the following equipment in the same manner as for normal vehicle diagnosis:
^
MUT-III PC
^
Reprogramming Database on DVD-ROM (Reflash Update CD 4106 or later for this concern)
^
VCI (Vehicle Communication Interface) - MB991824
^
MUT-III main harness B (red) - MB991911
^
Endeavor & 2005 Galant models only: MUT-III main harness A (blue) - MB991910
^
Outlander & Montero models only: 12-13 pin adapter MB991855
^
USB 2.0 cable - MB991827
c.
Connect the VCI to the vehicle.
d.
Disconnect the MUT-III laptop.
e.
IMPORTANT!
Lancer, Outlander, and Evolution models equipped with ABS: With the ignition key OFF, unplug the ABS fuse (7.5 amp fuse in the junction box
in the passenger compartment). Refer to the service manual for exact fuse location in the box.
f.
Reprogram the PCM, using "Automatic reprogramming" on the VCI. It will take up to 20 minutes to complete the reprogramming.
CAUTION
DO NOT DISTURB THE HARNESS CABLES OR CONNECTIONS. INTERRUPTION DURING THE PROGRAMMING PROCESS COULD
CAUSE THE PCM TO LOSE DATA OR PREVENT FUTURE PCM REPROGRAMMING.
If the message "ECU at Current Level of VCI" appears, the PCM did not reprogram. Verify that the ROM ID is the same as the ROM ID listed in the
table in Step 7.
^
If the ROM ID is the same or higher than the ROM ID in the table, the PCM has already been reprogrammed for this concern. Do not continue with
this reprogramming procedure.
^
If it is not, verify that the correct database update is in the MUT-III. Verify the correct database was transferred to the memory card, and that the
memory card is properly installed in the VCI.
