Montero V6-3.8L SOHC (2005)
Repairs and Inspections Required After a Collision: Service and Repair
Seat Belt Systems
POST-COLLISION DIAGNOSIS
To inspect and service the SRS after a collision (whether or not the air bags have deployed), perform the following steps.
SRS-ECU MEMORY CHECK
Required Special Tools:
-
MB991958: Scan Tool (MUT-III Sub Assembly)
-
MB991824: Vehicle Communication Interface (V.C.I.)
-
MB991827: MUT-III USB Cable
-
MB991911: MUT-III Main Harness B (Vehicles without CAN communication system)
CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991958.
1. Connect scan tool MB991958 to the data link connector (16-pin).
2. Read (and write down) all displayed diagnostic trouble codes.
NOTE: If the battery power supply has been disconnected or disrupted by the collision, scan tool MB991958 cannot communicate with the
SRS-ECU. Check the battery then check and, if necessary, repair the front wiring harness and the body wiring harness before proceeding.
3. Read the data list (fault duration and how many times memories are erased) using scan tool MB991958.
4. Erase the diagnostic trouble codes and, after waiting five seconds or more, read (and write down) all displayed diagnostic trouble codes.
REPAIR PROCEDURE
