Montero V6-3.8L SOHC (2005)
Disconnect the negative (-) battery cable from the battery and tape the terminal to prevent accidental connection and air bag(s) deployment.
INSTALLATION SERVICE POINTS
]]A[[ PRE-INSTALLATION INSPECTION
WARNING: Dispose of seat belt pre-tensioner only according to the specified procedure.
1. When installing the new seat belt pre-tensioner, refer to "INSPECTION".
2. Connect the negative (-) battery cable.
CAUTION: To prevent damage to scan tool MB991958, always turn the ignition, switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991958.
Scan Tool
3. Connect scan tool MB991958 to the data link connector.
4. Turn the ignition switch to the ON position.
5. Check DTCs using scan tool MB991958 to ensure entire SRS operates properly.
At this time, check that DTC except 26 and 28 is not set.
DANGER: Wait at least 60 seconds after disconnecting the battery cable before doing any further work.
WARNING: Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.
6. Turn the ignition switch to the "LOCK" (OFF) position. Disconnect the negative (-) battery cable and tape the terminal to prevent accidental
connection and seat belt pre-tensioner operation.
]]B[[ POST-INSTALLATION INSPECTION
