mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Front Impact Sensor|Page 644 > < Front Impact Sensor|Page 642
Page 2
background image

[[A]] NEGATIVE (-) BATTERY CABLE DISCONNECTION

DANGER:  Wait at least 60 seconds after disconnecting the battery cable before doing any further work.

WARNING:  Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.

Disconnect the negative (-) battery cable from the battery and tape the terminal to prevent accidental connection and air bag(s) deployment.

INSTALLATION SERVICE POINTS

]]A[[ PRE-INSTALLATION INSPECTION

Check the side impact sensor for dents, breakage and bending and measure the resistance between the terminals, even when installing a new side impact
sensor.

]]B[[ SIDE IMPACT SENSOR INSTALLATION

WARNING:  If the side impact sensor is not installed securely and correctly, the side air bag may not operate normally.

Securely connect the connector.

]]C[[ POST-INSTALLATION INSPECTION

1. Reconnect the negative (-) battery cable.
2. Turn the ignition switch to "ON" position.
3. Does the "SRS" warning light illuminate for approximately seven seconds, and then remain off for at least five seconds after turning "OFF"?

Front Impact Sensor|Page 644 > < Front Impact Sensor|Page 642