Montero V6-3.8L SOHC (2005)
Position the stabilizer clamp as shown in the illustration and then tighten the stabilizer clamp mounting bolt.
INSPECTION
^
Check the bushing for wear and deterioration.
^
Check the stabilizer bar for deterioration or damage.
^
Check all bolts for condition and straightness.
STABILIZER LINK BALL JOINT TURNING TORQUE CHECK
Required Special Tool:
^
MB990326: Preload Socket
1. After shaking the ball joint stud several times, install the nut to the stud and use special tool MB990326 to measure the turning torque of the ball
joint.
Standard value: 0.5 - 2.0 Nm (4 - 17 inch lbs.)
2. If the measured value exceeds the standard value, replace the stabilizer link.
3. If the measured value is lower than the standard value, check that the ball joint turns smoothly without excessive play. If so. it is possible to use
that ball joint.
STABILIZER LINK BALL JOINT DUST COVER CHECK
1. Press the dust cover with your finger to check that there are no cracks or damage in the dust cover.
2. If the dust cover is cracked or damaged, replace the stabilizer link.
NOTE: If the dust coverts cracked or damaged, it is possible that there may also be damage to the ball joint. When it is damaged during service
work, replace the dust cover.
STABILIZER LINK BALL JOINT DUST COVER REPLACEMENT
Only when the dust cover is damaged accidentally during service work, replace the dust cover as follows:
1. Remove the clip ring, and then remove the dust cover.
2. Apply the multipurpose grease to the inside of the dust cover.
3. Wrap plastic tape around the stabilizer link stud, and then install the dust cover to the stabilizer link.
4. Secure the dust cover in place with the clip ring.
5. Press the dust cover with your finger to check that there are no cracks or damage in the dust cover.
