Montero V6-3.8L SOHC (2005)
3. Tighten the nut of special tool MB990819 while measuring the turning torque of the drive pinion. Gradually keep tightening the nut of special
tool MB990819 until the turning torque of the drive pinion (without oil seal) is at the standard value.
Standard value (Without oil seal)
NOTE: The special too/ MB990326 cannot be turned a full revolution, so turn it several times within the range of movement to run in the
bearing, and then measure the turning torque.
4. Clean the side bearing hub.
5. Install special tools MB991170 and MB990819 to the side bearing hub of the gear carrier, and then install the bearing cap.
NOTE: Always check that the notch is in the shown position and that special tools are touching firmly against the side bearing hub.
6. Use a thickness gauge to measure the clearance (A) between special tools MB991170 and MB990819.
7. Remove special tools (MB991170, MB990819).