Montero 4WD V6-3.5L SOHC (1998)
1.
With the third-seat folded up in the stowed position, look at the shape of the striker holes in the cargo area carpet (mat). If "T"-shaped, proceed
with modifications. Also, check the third-seat striker/latch assemblies for proper operation. If the striker holes are rectangular (dimensions 63 mm
x 97 mm), the mat has already been modified. In this case, go to step 5.
2.
Remove the cargo area mat. On the back side of the mat, mark the new rectangular hole at each of the original "T"-shaped striker holes. Use the
included template as a guide.
NOTE:
Make sure to pay close attention to the positioning of the template. The new rectangular-shaped hole should start at the bottom of the original
"T"-shaped hole, and extend exactly 21 mm above the top of the "T". The 21 mm dimension is critical for proper striker operation.
WARNING:
3.
Be careful to avoid injury when using the knife to cut the mat.
Using a sharp carpet knife and a straight edge, cut out the new rectangular shape at each "T"-shaped striker hole.
NOTE:
