Montero 4WD V6-3.5L SOHC (1998)
E
SHAFT SEAL REMOVAL
Use a flat-tip (-) screwdriver to remove the shaft seal from the front housing.
REASSEMBLY SERVICE POINTS
A
SHAFT SEAL INSTALLATION
1. Lubricate the shaft seal with specified compressor oil.
Specified compressor oil: ND-OIL 8
2. Set the shaft seal to the front housing so that the projection side of the center ring is at the shaft seal side.
3. Use a 21 mm (0.83 in.) socket to install the shaft seal.
B
FRONT HOUSING INSTALLATION
1. Apply specified compressor oil to the shaft.
Specified compressor oil: ND-OIL 8
2. Install the front housing, taking care not to damage the lip part of the shaft seal.
