Montero 4WD V6-3.5L SOHC (1998)
CLOSED THROTTLE POSITION SWITCH CHECK
(1) With the accelerator pedal released, check that the throttle valve lever or the fixed SAS is pushed.
NOTE: If it is not pushed, adjust the fixed SAS. Refer to Closed Throttle Position Switch/Adjustments.
(2) Disconnect the throttle position sensor connector.
(3) Check for continuity between throttle position sensor connector terminal (1) (sensor ground) and terminal (2) (closed throttle position switch).
NOTE: If there is no continuity when the accelerator pedal is released, loosen the throttle position sensor installation screw; then, after
turning all the way in the clockwise direction, check again.
(4) Replace the throttle position sensor (with built-in closed throttle position switch) if there is a malfunction.
NOTE: For the closed throttle position switch and throttle position sensor adjustment procedure, refer to Closed Throttle Position
Switch/Adjustments.